KLS Martin marLED E9 - Closing the Lamp Casing



Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E15E9 / E9i / E15
V V 1.0 1.0 6363
1 1 Brake Brake screwscrew
•• Lubricate and insert brake screw (1) andLubricate and insert brake screw (1) and
screw on using a screwdriver.screw on using a screwdriver.
Fig. Fig. 6-10: 6-10: Inserting Inserting lubricated lubricated brake brake screwscrew
••
 Check connection locations of the cables,Check connection locations of the cables,
cables and cable fastening against yourcables and cable fastening against your
notes.notes.
Fig. Fig. 6-11: 6-11: Checking Checking the the assemblyassembly
6.216.21 Closing the casingClosing the casing
••

Turn the lamp body with the bottom of the lamp body facing down.Turn the lamp body with the bottom of the lamp body facing down.
•• Check all plug connections:Check all plug connections:
—— Cables must not be clamped.Cables must not be clamped.
—— The gasket must sit closely in all locations.The gasket must sit closely in all locations.
••
 Put on the lamp cover.Put on the lamp cover.
••
 Turn lamp body on the lamp cover.Turn lamp body on the lamp cover.