KLS Martin marLED E9 - Component Replacement Procedures; Control Electronics Setup and Microfuses



Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E15E9 / E9i / E15
V V 1.0 1.0 3333
6.16.1 Setup of the Control Electronics with MicrofuseSetup of the Control Electronics with Microfuse
The microfuses are located on locations (9) and (11).The microfuses are located on locations (9) and (11).
1 1 ConneConnection ction LE LE E9 E9 Field Field A A 6 6 – – x x – – 1111 MicroMicrofuse fuse 2 2 MasteMasterr
2 Co2 Connectnnection ion LE LE E15 E15 Field Field A A 7 Co7 Connectnnection ion LE LE E15 E15 Field Field B B 1212 DIP DIP SwitcSwitchh
3 3 – – x x – – 8 8 ConneConnectioction n LE LE E9 E9 Field Field B B 1313 ProgrProgrammiamming ng InterInterfaceface
4 4 ConneConnection ction for for operaoperating ting foil foil 9 9 MicroMicrofuse fuse 1 1 Slave Slave 1414 ConneConnection ction LE LE E15 E15 Field Field CC
5 5 Handle Handle Connection Connection 10 10 Cable Cable terminal terminal for for powerpower
supplysupply
See section 6.13.1See section 6.13.1
“Connections”, page “Connections”, page 49 for49 for
the configuration.the configuration.
1515 ConConnecnectiotion LE n LE E9 E9 FieField ld CC