KLS Martin marLED E9 - Replacing the Control Electronics Board; Replacing the Operating Foil



Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E9 / E9i / E15E15
40 40 V V 1.01.0
••
Unscrew center screws (2).Unscrew center screws (2).
••
 Turn the lamp body with the bottom of theTurn the lamp body with the bottom of the
lamp body facing down.lamp body facing down.
•• Remove the lamp cover.Remove the lamp cover.
The control electronics are now accessible.The control electronics are now accessible.
6.76.7

Replacing the Control ElectronicsReplacing the Control Electronics
Danger of electrocution!Danger of electrocution!
The lamp is operated at 100–240 VAC!The lamp is operated at 100–240 VAC!
For all work on the lamp, turn off the customer-side power supply and secure it againstFor all work on the lamp, turn off the customer-side power supply and secure it against
reactivation.reactivation.
•• Create access to control electronics (see section 6.6 “”, page 39).Create access to control electronics (see section 6.6 “”, page 39).
••
 Remove all plug connections (see section 6.11 “Plug Connections on Control ElectronicsRemove all plug connections (see section 6.11 “Plug Connections on Control Electronics
and Light Engine”, page 44).and Light Engine”, page 44).
•• Replace control electronics (see section 6.6 “”, page 39).Replace control electronics (see section 6.6 “”, page 39).
••
Re-establish all plug connections (see section 6.11 “Plug Connections on ControlRe-establish all plug connections (see section 6.11 “Plug Connections on Control
Electronics and Light Engine”, page 44).Electronics and Light Engine”, page 44).
6.86.8

Replacing the operating foilReplacing the operating foil
Danger of electrocution!Danger of electrocution!
In case of damage or incorrect installation of the electrical components (e.g. cables,In case of damage or incorrect installation of the electrical components (e.g. cables,
connectors, components), the suspension arm system may be energized. In this case there isconnectors, components), the suspension arm system may be energized. In this case there is
danger of electrocution!danger of electrocution!
••
 Ensure that no bare wires protrude from the terminals.Ensure that no bare wires protrude from the terminals.
WARNINGWARNING
WARNINGWARNING