KLS Martin marLED E9 - Guidelines and Manufacturers Declaration on Guidelines and Manufacturers Declaration on Electromagnetic Electromagnetic Compatibility

V. V. 1.0 1.0 9393


Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E9 / E9i / E15E15
1111

Guidelines and Manufacturer’s Declaration onGuidelines and Manufacturer’s Declaration on
Electromagnetic CompatibilityElectromagnetic Compatibility
Risk of injury due to Risk of injury due to use of unapproved devices and equipment!use of unapproved devices and equipment!
••
 Ensure that all devices present in the operating environment and / or other equipmentEnsure that all devices present in the operating environment and / or other equipment
have medical approval.have medical approval.
••
Check that the devices have the CE label and that a valid declaration of conformity isCheck that the devices have the CE label and that a valid declaration of conformity is
available.available.
••
 Devices and equipment thatDevices and equipment that do notdo notmeet the limits for electromagnetic emissions mustmeet the limits for electromagnetic emissions must
have a special label.have a special label.
Guidance and manufacturer’s declaration according to
Guidance and manufacturer’s declaration according to IEC 60601-1-2,IEC 60601-1-2,
clause 6.8.3.201 a) 3) Table 201: Electromagnetic emissionclause 6.8.3.201 a) 3) Table 201: Electromagnetic emission
The device is intended for operation in The device is intended for operation in a electromagnetic environment as indicated below. The usera electromagnetic environment as indicated below. The user
must ensure that it is operated in such an environment.must ensure that it is operated in such an environment.
Emission testEmission test
ComplianceCompliance
levellevel
ElectromagneElectromagnetic tic environment–Genvironment–Guidanceuidance
RF emissions according toRF emissions according to
EN 55011EN 55011
Group 1Group 1
The device uses electromagnetic energyThe device uses electromagnetic energy
exclusively for the performance of its internalexclusively for the performance of its internal
functions. This may cause interference in functions. This may cause interference in nearbynearby
electronic equipment.electronic equipment.
RF emissions according toRF emissions according to
EN 55011EN 55011
Class BClass B
The limits of this class are The limits of this class are kept only in standbykept only in standby
mode (without RF current activation)!mode (without RF current activation)!
Harmonic emissions accordingHarmonic emissions according
to IEC 61000-3-2to IEC 61000-3-2
Class CClass C
The device is suitable for use in The device is suitable for use in allall
establishments, including domestic establishments, including domestic establishmentsestablishments
and those directly connected to the public low-and those directly connected to the public low-
voltage power supply network that voltage power supply network that suppliessupplies
buildings used for domestic purposes.buildings used for domestic purposes.
Voltage fluctuations / flickerVoltage fluctuations / flicker
emissions according toemissions according to
IEC 61000-3-3IEC 61000-3-3
CompliesComplies
CAUTIONCAUTION