KLS Martin marLED E9 - Test Instructions for Intensive Maintenance

V V 1.0 1.0 7575


Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E15E9 / E9i / E15
7676 VV 1.01.0
10.310.3 Test Instructions for Intensive MaintenanceTest Instructions for Intensive Maintenance
The required checks, whoseThe required checks, whoseresults must be documented in the Test Report as part of theresults must be documented in the Test Report as part of the
Safety Check, have been subdivided into four sections:Safety Check, have been subdivided into four sections:
••

Checking the wall / ceiling assembly for Checking the wall / ceiling assembly for stabilitystability
••
 Checking potential equalization / protective conductor Checking potential equalization / protective conductor (PE) resistance(PE) resistance
••
 Checking the suspension arm systemChecking the suspension arm system
••
 Checking the light functionsChecking the light functions
If a test instruction is followed by the symbol (ticked box) shown below, you must documentIf a test instruction is followed by the symbol (ticked box) shown below, you must document
the test results in the appropriate section of the Test Report:the test results in the appropriate section of the Test Report:
••
 √√ (plus (plus torque)torque)
1.) Checking the Wall / Ceiling Assembly for Stability1.) Checking the Wall / Ceiling Assembly for Stability
Tools required:Tools required:
torque wrench, extension, attachments / bits 17 / 19 / 23, spirit leveltorque wrench, extension, attachments / bits 17 / 19 / 23, spirit level
a) Checking the wall / ceiling assemblya) Checking the wall / ceiling assembly
••
 Check all heavy-duty anchors and fixing nuts of the ceiling anchor plate (and of theCheck all heavy-duty anchors and fixing nuts of the ceiling anchor plate (and of the
intermediate ceiling assembly if applicable) for secure intermediate ceiling assembly if applicable) for secure fixation, taking due account of thefixation, taking due account of the
specifications below.specifications below.
Heavy-duty anchor torquesHeavy-duty anchor torques
Fig. Fig. 10-1: 10-1: Checking Checking the the torques torques of of the the heavy-duty heavy-duty anchorsanchors
••
 Heavy-duty anchor 10 / 20Heavy-duty anchor 10 / 20
Tightening torque (MP) = 50 Nm (used for round ceiling anchor plates)Tightening torque (MP) = 50 Nm (used for round ceiling anchor plates)
••
 Heavy-duty anchor 12 / 25:Heavy-duty anchor 12 / 25:
Tightening torque (MP) = 80 Nm (used for square ceiling anchor plates)Tightening torque (MP) = 80 Nm (used for square ceiling anchor plates)
NOTICENOTICE