KLS Martin marLED E9 - Removing the Light Engine



Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E9 / E9i / E15E15
36 36 V V 1.01.0
6.46.4 Removing the Light EngineRemoving the Light Engine
Danger of electrocution!Danger of electrocution!
The lamp is operated at 100–240 VAC!The lamp is operated at 100–240 VAC!
For all work on the lamp, turn off the customer-side power supply and secure it againstFor all work on the lamp, turn off the customer-side power supply and secure it against
reactivation.reactivation.
For removal, the assembly-disassembly tool is required (see section 12.1 “List of tools”,For removal, the assembly-disassembly tool is required (see section 12.1 “List of tools”,
page 98).page 98).
•• Raise the lever (2) of the assembly-Raise the lever (2) of the assembly-
disassembly tool (3).disassembly tool (3).
••
Place the assembly-disassembly tool (3)Place the assembly-disassembly tool (3)
onto the cover glass (4) of the Light Engineonto the cover glass (4) of the Light Engine
so that the handle (1) faces away from theso that the handle (1) faces away from the
center of the casing.center of the casing.
•• Lower the lever (2) to cause the assembly-Lower the lever (2) to cause the assembly-
disassembly tool (3) to adhere by suction todisassembly tool (3) to adhere by suction to
the glass lid of the Light Engine.the glass lid of the Light Engine.
••
 Slowly pull the handle (1) towards theSlowly pull the handle (1) towards the
center of the casing (A) until a gap (5)center of the casing (A) until a gap (5)
opens between the Light Engine and theopens between the Light Engine and the
casing.casing.
••
 Then pull the handle (1) in the direction ofThen pull the handle (1) in the direction of
(B) until the Light Engine detaches from the(B) until the Light Engine detaches from the
casing.casing.
•• Take Light Engine out of the lamp body onTake Light Engine out of the lamp body on
the assembly-disassembly tool withoutthe assembly-disassembly tool without
pulling on the cable.pulling on the cable.
••
Raise the lever (2) and remove theRaise the lever (2) and remove the
assembly-disassembly tool (3) from theassembly-disassembly tool (3) from the
Light Engine.Light Engine.
WARNINGWARNING