KLS Martin marLED E9 - Page 57



Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E15E9 / E9i / E15
V V 1.0 1.0 5757
Configuration on the programming Configuration on the programming adapteradapter
4 Slave4 Slave
5 Program5 Program
6 Master6 Master
7 Run7 Run
••
 Set the right switch (5) to “Program”.Set the right switch (5) to “Program”.
•• Use the left switch to select Master (6) or Slave (4) DSP.Use the left switch to select Master (6) or Slave (4) DSP.
•• Turn on power supply and switch on the marLEDTurn on power supply and switch on the marLED
®®
E9 / E9i / E15.E9 / E9i / E15.
The programming mode is activated only during power up.The programming mode is activated only during power up.
Programming instructions MasterProgramming instructions Master
••
 Use the left switch to select Master (6) DSP.Use the left switch to select Master (6) DSP.
Use of the C2Prog PC soUse of the C2Prog PC softwareftware
•• Start the C2Prog.exe program.Start the C2Prog.exe program.
••
 For the update of the Master DSP, under “File” select the *.ehx file to be programmed.For the update of the Master DSP, under “File” select the *.ehx file to be programmed.
•• Make the settings shown below under “Programming Configuration”.Make the settings shown below under “Programming Configuration”.
••
 Select the interface (2) under “Port”.Select the interface (2) under “Port”.
••
 Click the button “Program” (3).Click the button “Program” (3).
Program update Master DSP starts.Program update Master DSP starts.