KNS supertrack S3 - Operation; Front Panel Functions Overview

19
3. Operation
3.1. Front Panel Functions
1 . MENU button – Press the MENU button for more than 3 seconds to enter the
set-up mode. When you want to escape from the set-up mode, press MENU again
for more than 3 seconds. Another function of the MENU button is that of checking
the error message when the S3 makes an error. When the error LED is on, press
the MENU button briefly. Then, you will be able to see the hexadecimal error
message. Please press the NEXT button for about 2 seconds to clear the error. If
you press MENU briefly again, you can go back to normal operation.
2.
TRACK button – Press the TRACK button to enter the stall mode. The antenna
does not move from the position when the TRACK button is pressed. This button is
also used to scroll left (
◀ ) in the menu.
3.
NEXT button – Press the NEXT button to select your preprogrammed next
satellite. When your desired satellite is displayed, stop pressing NEXT, and then,
after 3 seconds, the antenna automatically searches for your desired satellite.
Use this button when you want to scroll right (
▶ ) in the menu.
4.
M/C button – Press M/C for more than 3 seconds to enter computer link via RS
232. When you want to escape from computer link, press M/C for more than 3
seconds. This button is also used to scroll up (▲) in the menu.
5.
SEARCH button – Press SEARCH for more than 3 seconds to re-search for the
current satellite. This button is also used to scroll down (▼) in the menu.
6.
PWR button (Power button) – Use this button when you want to turn on/off the
antenna unit power.
7. TRACK LED – Blinking indicates that the antenna is searching for the satellite.
ON indicates that the antenna is tracking the satellite.
OFF indicates that the antenna is in the stall mode or initializing.