40
NOTE: The LNB local frequency is the same in the same area.
SAT ID refers to the satellite index, as shown below.
ID 1~13: North America
ID 21~26: South America
ID 41~60: Europe
ID 61~74: Asia
Search Ref refers to the S3 search reference that was used as a reference during
the search for the satellite.
AGC THD: Search at a higher AGC level than the preset AGC level in the PCU.
C/N THD: Search at a higher C/N level than the preset C/N level in the PCU.
CLock: Search for the target DVB Carrier lock (Default).
NLock: Search for the satellite until the NID is locked. There is no function.
Track Ref refers to the S3 tracking reference that was used as a reference during
the tracking of the satellite.
AGC: Track the highest AGC level (Default).
C/N: Track the highest C/N level.
RSSD (Receive Signal Detector): Track the highest RSSD value. There is no
function.
RX Polarity refers to the RX polarity of the satellite.
Horizontal/Vertical
Network ID: If you know the correct network ID, input the correct value. Otherwise,
input ‘0’.
FEC mode: Select the FEC mode (DVB QPSK, DVB BPSK, DSS QPSK) according
to the target satellite’s FEC mode.
THRD Level refers to the threshold level if the searching reference is AGC THD or
C/N THD. The S3 searches for a higher signal than the threshold level.
Polarity refers to the voltage and tone of the LNB. The S3’s preset satellites are
‘HH’.
To Next Page
Loading...