Kodak RVG 6500 IPS System - Setting Up the KODAK RVG 6500 Systems; WiFi Access Point Setup Configurations

KODAK RVG 6500 System_User & Installation Guide (SM728)_Ed01 17
5 Setting Up the KODAK RVG 6500
Systems
WiFi Access Point Setup Configurations
There are 2 WiFi access point setup configuration options:
• The wired WiFi access point setup configuration
• The wireless WiFi access point setup configuration
You need to decide your setup configuration before starting the WiFi setup. Once you have decided
you will be guided by the setup software (see
Installing the Setup Installation Software).
WiFi Access Point Wired Configuration Setup
You can choose to have a wired WiFi access point configuration. In this configuration setup, the WiFi
access point is connected to a single computer through an Ethernet cable. Several sensors can be
connected to the same access point and computer.
The transmission range between the WiFi access point and the RVG sensor is up to 10 meters.
Important: Your computer must have an Ethernet board and be WiFi
equipped before installing the KODAK RVG 6500 systems.
NETGEAR
1234
max. 10m