KODAK RVG 6500 System_User & Installation Guide (SM728)_Ed01 65
Replacing the RVG Battery
To replace the RVG battery, follow these steps:
1 Turn OFF the RVG sensor.
2 Make sure that the RVG sensor is not connected to the mains outlet.
1 Press down with fingers and slide the trap door (A) protecting the battery on the back of the
control box.
2 Remove carefully the connector (B) to remove the used battery.
3 Insert the connector (B) of the appropriate battery.
4 Slide and close the trap door (A) protecting the battery.
RVG Control Box
A
A
WARNING: Make sure that the battery is inserted correctly in its
connector.
A
B
To Next Page
Loading...
