Vers. 062721 40
The speed and torque utilized in the PRE-TIGHTENING REVERSE phase are set in the
REVERSE SPEED and REVERSE TORQUE settings above.
This function activates only if the screw result from the tightening phase was OK. If
there was an error in executing or completing the tightening phase, the screwdriver will
not proceed with the AUTO-REVERSE AFTER TORQUE phase.
WARNING: the lever must remain pressed or the remote start command must remain
active during the entire AUTO-REVERSE AFTER TORQUE phase, otherwise the
screwing result will be NOK and an error will be raised.
If OFF, this functionality is disabled.
Note: if the tightening phase was successful, the OK signal will not be raised until the
completion of the AUTO-REVERSE AFTER TORQUE phase. The TORQUE and ANGLE
results displayed at the end of the AUTO-REVERSE AFTER TORQUE phase will
correspond to the torque/angle results from the tightening phase, and not those from
the AUTO-REVERSE AFTER TORQUE phase.
(7) AUTO-REV DELAY
The amount of idle time between the end of the tightening phase and the AUTO-
REVERSE AFTER TORQUE phase. The lever must remain pressed or the remote start
command must remain active during this idle time. Cannot be set to less than 0.3
seconds. Only active if the AUTO-REVERSE AFTER TORQUE function is not OFF.
(8) Exit/Save Key
Tap to return to the previous menu and save or discard any changes made.
OTHER menu
(1) Program number
Indicates the program that is currently being edited. You can select a different program
to edit from the previous screen.
(2) DESCRIPTION
Tap to enter a program description of up to 28 alphanumeric characters. The description
will be displayed in the main screen.
To Next Page
Loading...
Need help?
General
