Vers. 062721 16
TERMINOLOGY
KDU/K-DUCER/control unit: the KDU1 / KDU1A control unit
KDS/screwdriver: the transducerized screwdriving tool to be used with the KDU control
unit
Transducer: electronic component installed inside the KDS screwdriver which measures
the torque in real time
Rundown/tightening: the screwdriving cycle, from start (pressing of the lever or initiating
remote lever control), to finish (automatic motor stop or lever or remote lever control
release, whichever happens first)
Torque: rotational force
Closing torque: the last torque value measured when the screwdriver motor stopped or
when the screwdriver lever or remote lever control was released
Target torque: the closing torque that the screwdriver system will apply in the rundown
(torque control mode only), resulting in a “Screw OK” result if successful
Prevailing torque: an optional phase of the rundown during which the applied torque is
allowed to exceed the target/closing torque
Torque control mode: a rundown where the screwdriver motor automatically stops upon
reaching the target torque
Angle: the revolutions of the tip of the screwdriver, in degrees. The start time of the angle
measurement depends on the settings chosen.
Target angle: the angle measurement upon which the screwdriver motor will stop (angle
control mode only), resulting in an “Angle OK” result if successful
Angle control mode: a rundown where the screwdriver motor automatically stops upon
reaching the target angle
Run time: the duration of the rundown, in seconds
Run time mode: a rundown where the screwdriver motor automatically stops at the
desired run time
To Next Page
Loading...
