.
OPERATION
DETAILED CONTROLS AND GAUGES
AUXILIARY ELECTRIC POWER
NOTICE
When installing electrical equipment not supplied by Komatsu, make sure that the equipment is 24 V specification with a
maximum of 240 W (10 A or equivalent). When installing electrical equipment with a larger capacity, please consult your Komatsu
distributor.
On both the left and right sides under the floor console, there are power takeoff connectors for optional equipment
fixed to the wiring and held in position by tape. Remove the tape when using them.
Use these connectors for taking off the power supply for components not supplied by Komatsu.
Left connector No: M10
Right connector No: M09
See the table below for the connection type of each connector. (Both left and right)
M type housing (2-terminal) Terminal
Body Rear holder AVS 0.5 AVS 0.85 - 2 AVS 3
Komatsu part No. 08056-00211 08056-00230 08056-00050 08056-00051 08056-00052
REMARK
Power may be sourced from the cigarette lighter, too. For the details, see the section of "Cigarette Lighter (PAGE
3-69)" in this manual.
3 - 110
To Next Page