.
ATTACHMENTS AND OPTIONS
BUCKET WITH HOOK
BUCKET WITH HOOK
HOOK CONDITION
Check that there is no damage to the hook, stopper, or hook mount. If there is any problem, contact your Komatsu
distributor.
PROHIBITED OPERATIONS
Operations with Care
Do not exceed the following loads when carrying out lifting
operations.
When standard arm is installed: 700 kg (1544 lb)
When long arm is installed: 500 kg (1103 lb)
It is dangerous if the load sways excessively. Lower the engine
speed and operate the control levers slowly.
The swing speed of this machine is 3 to 4 times the speed of a
mobile crane. Be particularly careful to check that the
surrounding area is safe when operating the swing.
Check that there is no damage to the hook, stopper, and hook
mount. If any problem is found, please contact your Komatsu
distributor.
Never travel the machine while lifting a load.
Depending on the operating posture, there is danger that the
wire or pulley may come off from the hook. To avoid these parts
from coming off, pay careful attention to the angle of the hook.
In addition, do not allow any person to come under or in the area
around a raised load.
If the bucket with hook is turned and used for operations, it will
hit the arm during dumping operations, be careful when using it.
If a hook is to be installed, please consult your Komatsu
distributor.
If you are planning to newly install a hook, contact your Komatsu distributor.
6 - 4
To Next Page