.
MAINTENANCE
MAINTENANCE PROCEDURE
CHECK SWING MACHINERY CASE OIL, ADD OIL
WARNING
The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to
go down before starting the operation.
1.
Remove dipstick (G) and wipe the oil from the dipstick with a
cloth.
2. Fully insert dipstick (G) into the filler pipe.
3.
When dipstick (G) is pulled out, if oil level is between the H and
L marks of the gauge, oil level is proper.
4. If the oil is not up to the L mark on dipstick (G), remove the from
oil filler port (F) and add oil.
5.
If the oil level exceeds the H mark on the oil level gauge, loosen
drain plug (P) to drain the excess oil, after swinging the upper
structure so that drain plug (P) comes between the right and
left tracks.
6. After checking oil level or adding oil, insert the dipstick into the
hole and install oil filler cap.
4 - 48
To Next Page