Komatsu PC138US - Machine Inspection after Daily Work

.
OPERATION
MACHINE OPERATIONS AND CONTROLS
OPERATION
MACHINE OPERATIONS AND CONTROLS
5. Set lock lever (2) to LOCK position (L) and stop the engine.
For details of the procedure for stopping the engine, see
"STOPPING THE ENGINE (PAGE 3-149)".
MACHINE INSPECTION AFTER DAILY WORK
Before Stopping Engine
Use the machine monitor to check engine coolant temperature (1),
engine oil pressure (2), and fuel level (3).
After Stopping Engine
1.
Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check for
any leakage of oil or coolant. If any problems are found, repair them.
2.
Fill the fuel tank.
3.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4. Remove any mud affixed to the undercarriage.
3 - 174