.
OPERATION
MACHINE OPERATIONS AND CONTROLS
Blade During Backhoe Operations
(Only machines with blade specification)
When carrying out deep digging operations with the blade at the
front, be careful not to the boom cylinder hit the blade. Always
position the blade at the back unless it is needed at the front.
Permissible Water Depth
CAUTION
When driving the machine out of water, if the angle of the machine exceeds
15°, the rear of the upper structure will go under water, and water will be
thrown up by the radiator fan. This may cause the fan to break.
Be extremely careful when driving the machine out of water.
Do not drive the machine in water deeper than the center of carrier
roller (1).
Supply grease to the parts which have been under water for a long
time until the used grease is projected out of the bearings (around
the bucket pin, in particular).
3 - 164
To Next Page