6
Application Functions
6-46 bizhub 500/420
6.7.1 Setting Repeat Times Automatically
Select the Auto Detect or Set Range mode to automatically detect or
manually specify the original image size, then let the machine determine the
number of repeats from specified mode and magnification ratio.
To automatically set the repeat times
0 Scan the original from original glass with the ADF kept open. The ADF
cannot be used to scan the original.
0 Auto Detect mode uses Non-Image Area Erase function to automatically
detect the original size.
0 Use Set Range mode to repeat a part of the original, not the entire image,
by specifying the scanning area.
Select the standard size or enter the dimensions of custom size.
Available dimensions: 30.0 ~ 432.0 mm for side X, 30.0 ~ 297.0 mm for
side Y
0 Select With Margin to repeat the image within the printing area leaving 3
mm from the leading edge, 4 mm from the rear edge, and 2 mm each
from left and right edges of selected paper size.
When Without Margin is selected, the original image will be repeated to
the margin area in which an image loss is likely.
0 Tray 1 will be automatically selected as copy paper tray source.
Change the tray selection manually, if desired. Auto Paper Select will not
function.
0 Auto Zoom will not function. Specify the desired magnification ratio.
1 Position the original on the original glass.
– Keep the ADF open.
2 Enter the desired print quantity from the control panel keypad.
3 Load the desired copy paper into any tray.
To Next Page
Loading...
Need help?
General
