Finishing/Folding
7
bizhub 500/420 7-21
To copy using Punch mode
0 If Punch is to be selected, select the orientation in which the original is
positioned and the orientation of the page to be punched, otherwise the
copies may not be punched as desired.
0 This mode is available in combination with Group, Sort + Offset, Group +
Offset, or Staple mode.
0 If punch position setting is different from the binding position specified in
Page Margin of Application setting, the punch position is given priority.
0 With Auto selected on the Punch Position popup menu, the punch
position will be determined automatically to the longer side for A4 copy
paper, or to the shorter side for copy paper larger than A4.
0 Be sure that the side guide plates of the paper tray are securely aligned
to the paper; otherwise the copies may not be punched in position.
0 Available paper weight for Punch Unit PU-501 mounted on Finisher FS-
510 is 56 to 90 gm
2
, while paper weight for Finisher FS-511 is 60 to 90
gm
2
. For details of other specifications, see "Paper Weight" on
page 10-4.
0 If the ATS (Automatic Tray Switching) functions while the machine uses
the Punch mode, the punch holes may be slightly off the appropriate
positions.
0 Do not punch special paper type such as overhead projection
transparent films, labels, etc.Otherwise, machine trouble may occur.
0 Each output tray of Finisher FS-510 and FS-511 has a limit in capacity.
Be careful not to exceed the limit. For details, see "Paper Tray/ Output
Tray Capacity" on page 10-5.
1 Position the original to be copied.
2 Using the keypad, enter the desired number of copies.
To Next Page
Loading...
Need help?
General
