Konica Minolta CHROMA METER - Installing Batteries

Installing Batteries
WARNING
(Failure to adhere to the following instructions may result in death or serious
injury.)
Do not put the batteries into a re and do not recharge, short-circuit, heat, or
disassemble them. Doing so may cause the batteries to explode or leak, leading to a
re or an electric shock.
If leaked battery uid gets in a persons eyes, wash the eyes with clean water without
rubbing and then seek medical attention immediately. If leaked uid comes in contact
with hands or clothes, rinse it off thoroughly with water. Do not continue the use of a
leaking battery.
When discarding the batteries used in the instrument, isolate the terminals with tape
or other material. Otherwise, any contact with a metal object may cause heat, an
explosion, or a re. Make sure that the batteries are either disposed of or recycled
correctly in accordance with local laws and regulations.
Do not continue the use of the instrument if it is damaged or if it produces smoke or
odd smells. Doing so may cause a re. In such situations, turn the power OFF
immediately, disconnect the AC adapter from the AC outlet and/or remove the
batteries, and contact the nearest KONICA MINOLTA-authorized service facility.
Do not touch or hold the batteries with wet hands. Doing so may cause an electric
shock or a breakdown.
CAUTION
(Failure to adhere to the following instructions may result in injury or physical
damage.)
Do not use any batteries other than those specied for the instrument. Do not use a
new battery and an old battery or batteries of different types together. When loading
the batteries in the instrument, ensure they are oriented according to the polarity
indication (positive ⊕ and negative ⊖) on the instrument. Otherwise, the batteries may
break or leak, resulting in a re or injury, or contamination of the area.
Do not use wet batteries. Do not use the instrument while water remains in the battery
compartment. This may cause the batteries to explode or produce heat, leading to a
re or injury.
Notes on Use
If the instrument will not be used for more than two weeks, remove the batteries from it.
Otherwise, the batteries may leak, resulting in damage to the instrument.
To avoid unnecessary battery consumption, you can set the instrument to activate Auto
Power Off when no operation is made for ve minutes. For details, refer to page 50.
When both the batteries and AC adapter or PC are used, the power is supplied through the
USB cable. This does not charge the batteries.
20
Preparation
BATTERY