4. The screen for selecting the Peak/
Valley measurement is displayed.
Press the
UP
key or
DOWN
key to
select the measurement mode.
When < Peak Measurement > is selected, the
maximum value of the measured values is
shown as the measurement result.
When < Valley Measurement > is selected, the
minimum value of the measured values is shown
as the measurement result.
5. Press the
ESC
key.
The measurement screen is displayed on the
LCD screen.
Even when the Peak or Valley measurement has
been set, normal measurement will be
performed for the user calibration and target
measurement.
The maximum/minimum value selection is
stored even when the power switch is set to
OFF ().
33
Settings
PEAK/
VALLEY
To Next Page