KTD-00782-H KTQ45 family Page 78 of 92
6.8.1 Boot – Boot Settings Configuration
Boot Settings Configuration
Allows BIOS to skip
certain tests while
booting in order to
decrease boot time.
<-> Select Screen
|| Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
Quick Boot [Enabled]
Quiet Boot [Disabled]
AddOn ROM Display Mode [Force BIOS]
Bootup Num-Lock [On]
PS/2 Mouse Support [Auto]
Wait for ‘F1’ If Error [Enabled]
Hit ‘DEL’ Message Display [Enabled]
Interrupt 19 Capture [Disabled]
Force boot Device [Disabled]
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
Allows BIOS to skip certain tests while booting in
order to decrease boot time.
Disabled: Displays normal POST messages.
Enabled: Displays OEM Logo (no POST messages).
Black Screen: No picture.
White Screen: White picture.
Set display mode for Option ROM.
Select Power-on state for numlock
Select support for PS/2 Mouse.
Wait for ‘F1’ If Error
(see note)
Wait for F1 key to be pressed if error occurs.
Hit ‘DEL’ Message Display
Displays “Press DEL to run Setup” in POST.
Enabled: Allows option ROMs to trap interrupt 19
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
Third IDE Master
Third IDE Slave
5
th
IDE Master
6
th
IDE Master
RAID
Any Harddrive (Above)
Overrides current boot setting. Device must be in the
boot priority menu, though. If the device fails to boot,
the system will NOT try other devices.
Note: List of errors:
Primary Master Hard Disk Error
Interrupt Controller-1 error
PCI IRQ routing table error
Halt on Invalid Time/Date
To Next Page
Loading...
