Korg Grandstage X - Page 28

Grandstage X - Selecting and playing sounds
28
Selecting sounds for splits
When you play the keyboard, the right side of the keyboard plays the program for the MAIN part, and
the left side of the keyboard plays the program for the SPLIT part.
1 Select the program to use for the MAIN part.
→ Selecting the main sound program
2 Press the SPLIT button in the PART CONTROL section (the button lights up).
In split mode, the keyboard is divided at C4 (default setting) into two parts.
On the display, the upper row shows the program name for the MAIN part, and the lower row
shows the program name for the SPLIT part.
3 Use the MAIN and SPLIT part sliders to adjust the volume.
4 Press the  or  buttons to the left of the display to select the name of the program used by the
lower SPLIT part.
The lower part is automatically selected when you switch SPLIT from OFF to ON.
5 Use the buttons, value dial or the +/- buttons in the SOUND SELECT section to select the
programs for the SPLIT parts. You can also select the programs from the list.
→ Selecting a program from the program list
6 To set the split point (the note on the keyboard where the parts are divided—the default setting is
C4), press a key while holding down the SPLIT button.