Korg Grandstage X - Page 29

Grandstage X - Selecting and playing sounds
29
Setting a layer and split at the same time
When you play the keyboard, the right side of the keyboard plays the programs for the MAIN and
LAYER parts, and the left side of the keyboard plays the program for the SPLIT part.
1 Select the program to use for the MAIN part.
→ Selecting the main sound program
2 Press the LAYER and SPLIT buttons in the PART CONTROL section (both buttons light up).
The keyboard is divided at C4 (default setting) into a SPLIT part and a MAIN/LAYER part.
On the display, the upper row shows the program name for the MAIN part, the middle row shows
the program name for the LAYER part, and the lower row shows the program name for the SPLIT
part.
3 Use the MAIN, LAYER and SPLIT part sliders to adjust the volume.
4 Press the  or  buttons to the left of the display to select the programs used by each part.
You can also select the programs from the list.
→ Selecting a program from the program list