2–3: Pitch (Track 1–8)
92
2–3: Pitch (Track 1–8)
2–4: Pitch (Track 9–16)
Here you can specify the song name, the scale, and the pitch of each track.
For details on the song name and scale, refer to “2–1: Track Parameter” (☞ page 89 in this man-
ual).
2–3c: Use Program’s Scale
This setting determines the scale used by each track.
If this is checked, the scale specified in Program Edit mode “1–1e: Scale” (☞ page 6 in this man-
ual) will be used.
If this is un-checked, the scale specified for the song in “2–1b: Scale” will be used.
2–3d: Transpose [–24…+24]
Adjusts the pitch of each track in semitone steps.
This setting has no effect on the MIDI note data that is transmitted.
This setting will change if a MIDI RPN Coarse Tune message is received.
2–3e: Detune [–99…+99]
Adjusts the pitch of each track in steps of one cent.
This setting has no effect on the MIDI note data that is transmitted.
This setting will change if a MIDI RPN Fine Tune message is received.
2–3f: Bend Range [PRG, –24…+24]
Specifies the range of pitch change (in semitone steps) that will occur in response to pitch bend
messages.
With positive (+) settings, the pitch will rise when the joystick is moved to the right, and will fall
when the joystick is moved to the left. With negative (–) settings, the opposite will occur.
With a setting of PRG, the pitch bend range will be determined by the setting of Program Edit
mode “2–1: OSC1 Pitch Mod” and “2–3: OSC2 Pitch Mod” (☞ page 12, 20 in this manual); i.e., the
setting of the program used by that track.
With a setting of other than PRG, pitch bend messages will affect the pitch within the specified
range. This setting will change if a MIDI RPN Pitch Bend Range message is received.
Page Menu
Track No.
2–3c
2–3d
2–3e
2–3f
2–3A
2–3B
2–3C
2–3D
Refer to “2–1:
Track Parameter”
Information for the
selected track
To Next Page
Loading...
Need help?
General
