Korg Trinity V3 User Manual

2–1: Filter, Protect & Data Dump
136
Global P2
2–1: Filter, Protect & Data Dump
2–1a: Filter
Enable Program Change
This specifies whether or not MIDI Program Change messages will be transmitted and received.
If this is
checked , Program Change messages will be transmitted and received. However, the
“Enable Bank Change” and “Enable Combination Change” settings will apply.
In Program Play mode, programs will be selected by incoming Program Change messages on a
channel that matches the Global MIDI channel.
When you select a program, a Program Change message will be transmitted on the Global MIDI
channel.
In Combination Play mode, combinations will be selected by incoming Program Change messages
on a channel that matches the Global MIDI channel. However this can be disabled by the “Enable
Combination Change” setting.
Incoming Program Change messages whose channel matches the channel settings of Combination
Edit mode “1–1e: MIDI Channel” ( ☞
page 58 in this manual) will select programs for that timbre.
When you select a combination, a Program Change message will be transmitted on the Global
MIDI channel, and also simultaneously transmitted on the channel of each timbre whose Combi-
nation Edit mode “1–1d: Timbre Mode” parameter ( ☞
page 58 in this manual) is set to EXT.
In Sequencer mode, incoming Program Change messages on a channel that matches the channel
setting of a track whose Track Status is INT or BOTH will select programs for that track.
When you select a song or playback a sequence, Program Change messages will be transmitted on
the channel specified for each track whose Track Status is EXT or BOTH.
If “Enable Bank Change” is checked, Bank Select messages will be transmitted together with Pro-
gram Change messages.
If “Enable Program Change” is
un-checked , Program Change messages will be neither transmit-
ted nor received.
Enable Bank Change
This specifies whether MIDI Bank Select messages will be transmitted and received.
If this is
checked , both Bank Select and Program Change messages will be transmitted and
received if “Enable Program Change” is checked.
If this is
un-checked , only Program Change messages will be transmitted or received if “Enable
Program Change” is checked.
When recording to the sequencer, Bank Select messages will be recorded regardless of this set-
ting, but playback will be affected by this setting.
2–1a
2–1b
Page Menu
2–1A
2–1B
2–1C
2–1D
2–1E
2–1F

Korg Trinity V3 Specifications

General

Brand	Korg
Model	Trinity V3
Category	Recording Equipment
Language	English