1–1: Combination Play
55
3. Combination Play mode
Combination Play P1
In Combination Play mode you can select factory set (pre-loaded) combinations.
The number of combinations available on the
TRINITY series
will depend on whether the Play-
back Sampler/Flash ROM option is installed. For details refer to page 9 of the Basic Guide.
If no options have been installed, the
TRINITY
allows you to select
256 combinations
(0–127 for
each bank A and B).
A list of the factory preset combination names is included in the separate
Voice Name List
.
1–1: Combination Play
1–1a: Bank (Bank Select) [Bank A…D]
Use the front panel [BANK] key to select the bank.
If the Playback Sampler/Flash ROM option is installed, you can select from banks C and D.
1–1b: Combination Number/Combination Name [0…127]
Use the VALUE controllers or a pedal switch to select combinations.
For details on selecting combinations using a foot switch or using MIDI Program Change mes-
sages from an external device, refer to Basic Guide page 15, “3. Select and play a combination”.
1–1c: Bank/Program
Selects the program for each timbre 1 through 8.
A bank M program can be selected only for one timbre.
This parameter is also displayed in Combination Edit mode “1–1: Timb Param 1” (
☞
page 57 in
this manual), and can be set from either location.
If “1–1d: Timbre Mode” is INT, you can change programs via MIDI.
When you change combinations, timbres whose Timbre Mode is EXT will transmit MIDI mes-
sages indicating the bank and program number that you have selected here.
Bank [A…M]
Selects the Bank for the program assigned to each timbre 1 through 8.
Bank M can be selected if the optional MOSS-TRI board is installed.
Program [0…127]
Selects the program for each timbre 1 through 8.
If the optional MOSS-TRI board is installed, you can select bank M programs 0–63. In addition, if
the Playback Sampler/Flash ROM option is installed, you can select bank M programs 64–127.
1–1a
1–1b
Timbre No.
1–1c
1–1d
1–1e
Page Menu
1–1A
1–1B
To Next Page
Loading...
Need help?
General
