5–2: Amp 1 EG (Amplifier 1 EG)
44
5–2: Amp 1 EG (Amplifier 1 EG)
These settings determine how the volume of oscillator 1 will change over time.
5–2a: Amplifier EG
Makes Level and Time settings to specify the time-variant change produced by the amp EG.
Level
Start (Start Level) [0…99]
This is the volume level at Note-on. If you want the sound to have an immediate attack, set this
parameter to a high value.
Attack (Attack Level) [0…99]
Specifies the volume level reached when the Attack Time has elapsed.
Break (Break Point Level) [0…99]
Specifies the volume level reached when the Decay Time has elapsed.
Sustain (Sustain Level) [0…99]
Specifies the volume level maintained from when the Slope Time has elapsed until Note-off.
Time
Attack (Attack Time) [0…99]
Specifies the time over which the volume will change from Note-on to the Attack Level. If the Start
Level is 0, this setting will determine how quickly the sound begins.
Decay (Decay Time) [0…99]
Specifies the time over which the volume will change from the Attack Level to the Break Point
Level.
Slope (Slope Time) [0…99]
Specifies the time over which the volume will change from the Break Point Level to the Sustain
Level.
Release (Release Time) [0…99]
Specifies the time from Note-on until the volume reaches 0.
5–2a
5–2b
5–2c
Page Menu
5–2A
5–2B
5–2C
5–2D
Note-on
Note-off
Attack
Time
Decay
Time
Release Time
Attack Level
Sustain
Level
Time
Break Point
Start Level
Slope
Time
Amplifier EG
Volume
To Next Page
Loading...
Need help?
General
