4–3: Filter 2 EG
39
4–3: Filter 2 EG
This page will be displayed if “1–1c: Oscillator Mode” is set to double.
Here you can make settings for the filter EG that will create time-variant changes in the cutoff fre-
quency of filter 2.
Refer to “4–1: Filter 1 EG”.
4–4: Filter 2 LFO
This page will be displayed if “1–1c: Oscillator Mode” is set to double.
Here you can make settings for the LFO that will create cyclic changes in the cutoff frequency of
filter 2 (a wah effect).
Refer to “4–2: Filter 1 LFO”.
To Next Page
Loading...
Need help?
General
