To Next Page

To Previous Page

4–2: Filter 1 LFO

With negative (–) settings, this will set the LFO Fade Out Time; i.e., the time over which the LFO

amplitude decreases from maximum down to 0.

If KeySync is Off, this will affect only the ﬁrst-started LFO.

4–2c: Frequency Modulation

These settings allow Alternate Modulation to affect the speed of the ﬁlter 1 LFO.

Alternate Modulation

AMS (Alternate Modulation Source) [OFF…Filter1 LFO]

Selects the source that will control the frequency of the oscillator 1 LFO.

With a setting of OFF, there will be no modulation.

Intensity [–99…+99]

Refer to “2–2c: Frequency Modulation.”

For details on how Alternate Modulation and the other AMS functions operate, refer to page 157

“8. Appendix” in this manual and to page 33 “About alternate modulation” in the Basic Guide.

▼ Page Menu Command

4–2A: Write Program

This command writes an edited program into the speciﬁed program number of the speciﬁed bank.

Be sure to write important programs. If you turn the power off or select a different program before

writing, the data cannot be recovered.

For details refer to Basic Guide page 23, “9. Writing a program or combination.”

4–2B: Copy Oscillator

This command copies the settings of oscillator 1 or 2 from the speciﬁed program to the oscillator of

the program being edited. You may also select a program from another bank as the copy source.

When copying Oscillator 2 to Oscillator 1, if Filter 1 EG, Amp 1 EG, Oscillator 1 LFO, or Filter 1

LFO is selected for Oscillator 2 AMS, the settings will be automatically converted from Filter 1

EG to Filter EG, from Amp 1 EG to Amp EG, from OSC 1 LFO to OSC LFO, and from Filter 1

LFO to Filter LFO.

4–2C: Swap Oscillator

This command exchanges the settings of oscillator 1 and 2 within the program being edited.

If an Oscillator 2 with AMS settings of Filter 1 EG, Amp 1 EG, Oscillator 1 LFO, or Filter 1 LFO

is used for Oscillator 1 as a result of a Swap Oscillator command, the settings will be automat-

ically converted from Filter 1 EG to Filter EG, from Amp 1 EG to Amp EG, from OSC 1 LFO to

OSC LFO, and from Filter 1 LFO to Filter LFO.

Korg Trinity V3 User Manual

Questions and Answers: