7–1: Effect Grouping
69
Combination P7
In this page you can make insert effect settings for timbres 1 through 8.
7–1: Effect Grouping
Here you can specify effect grouping. The actual insert effects for each timbre are specified in “7–2:
Insert Effects” which follows.
When you specify insert effects in a combination, the total Effect Size for all timbres must be 8 or
less. That is, if you wish to use a different insert effect for each timbre, all timbres must be set to an
effect size of 1.
It is possible to input the audio signal of a timbre into the insert effect specified for a different tim-
bre. That is, the insert effect of a timbre can be used by two or more timbres; this is called the
Grouping function.
We recommend that you make a group for each set of timbres that use similar insert effects, select
a timbre to act as the source for the group, and make insert effects for each group.
For details refer to the separate Effect Guide.
7–1a: FX Size [OFF, 1, 2, 4, 8, T–1…T–8]
Specifies the Effect Size of the insert effect used by each timbre.
For settings of 1, 2, 4 or 8, make insert effect settings in “7–2: Insert Effects”.
The timbres selected here will be affected by these settings, so first select the timbres here, then
specify the insert effects in “7–2: Insert Effects,” and finally set effect parameters in “7–3: Effect
Parameter.”
However the total for timbres 1–8 must be 8 or less. For example if two timbres are set to an Effect
Size of 4, it will not be possible to make Effect Size settings for any other timbres. (It will not be
possible to specify different insert effects for other timbres.)
For settings of T–1 through T–8, you can group timbres with effects specified for another timbre.
For example if you are using a flanger on timbre 3, you could set the Effect Size of timbre 5 to T–3.
This would mean that timbre 3 is the grouping source, and the audio signals of timbre 3 and tim-
bre 5 would be input to the flanger specified by timbre 3. This status is also displayed in the LCD.
Incoming MIDI control messages on a channel that matches the MIDI channel of a timbre will con-
trol the insert effect of that timbre. Thus if you wish to use incoming MIDI messages to control an
insert effect, match the MIDI channel of the messages to the MIDI channel of the timbre. For
details refer to Basic Guide page 64.
Page Menu
Timbre1
Effect Grouping
display
Timbre8
Timbre No.
7–1a
7–1A
Effect in use ( Effect Size1 Effect Size2 Effect Size4 for a timbre program that uses a drumkit)
Data for the
selected timbre
To Next Page
Loading...
Need help?
General
