6–1: Pattern Edit
119
6–1J: Copy To Track
This command copies the contents (musical data) of the pattern specified in the tab 1 display to a
track. Unlike the Put To Track command, the data itself is recorded into the track, and editing the
copied data will not affect the pattern or other locations.
When the Copy To Track command is executed, the data will be affected in the following ways:
• Musical data previously existing in the copy destination measures will be erased.
• The musical data that was copied will be played back using the time signature of the measures
to which it was copied.
Specify the pattern in the tab 1 display, and select this command. The rest of the procedure is the
same as for Put To Track. For details refer to “6–1I: Put To Track.”
1 432
1 432
Pattern 41
Example: Copy the musical data of pattern 41 to measure 2
Before Copy
After Copy
To Next Page
Loading...
