1–1: Prog Basic (Program Basic)
7
Stretch
is a tuning for acoustic piano.
All Range User Scale
allows you to specify in Global mode “3–1a: All Notes” (
☞
page 140 in this
manual) the tuning of each note in the entire range (C–1 to G9).
Key (Scale Key) [C…B]
Specify the tonic note of the selected scale.
Random [0…7]
As this value is increased, the pitch at which a note is sounded will become increasingly erratic.
Normally you will set this to
0
.
This setting is useful when you wish to simulate instruments which tend to have a naturally inac-
curate pitch, such as analog synthesizers or acoustic instruments.
1–1f: Panel Switch Assign
These settings assign the functions of the front panel switches SW1 and SW2 (assignable panel
switches 1 and 2).
SW1 [JS(X)Lock…Modulation (CC #80)]
SW2 [JS(X)Lock…Modulation (CC #81)]
The same functions are available for assignment to SW1 and SW2 (except for Modulation), as fol-
lows.
If you use one of these switches to
Lock
a controller such as the joystick, ribbon controller, or after-
touch, the selected controller will lock (LED lit) or unlock (LED unlit) each time you press SW1 (or
SW2).
If you press SW1 (or SW2) while operating a controller, the controller value will be fixed at the cur-
rent value, and will not change further. For example if you select JS(+Y) Lock, and press SW1 (or
SW2) when the joystick has been moved away from you, the joystick (+Y) movement will be
locked (held) at that position, so that modulation will continue to apply even after the joystick is
returned to its normal position. By moving the joystick in the (–Y) direction you can then apply
two types of modulation at once.
When a controller is locked, that controller will not transmit MIDI messages, but the correspond-
ing MIDI message will still be received.
With a setting of
Octave Up
, the pitch will alternate between a pitch of one octave higher (LED lit)
and the normal pitch (LED unlit) each time you press SW1 (or SW2).
With a setting of
Octave Down
, the pitch will alternate between a pitch of one octave lower (LED
lit) and the normal pitch (LED unlit) each time you press SW1 (or SW2).
With a setting of
Portamento Off
, the portamento effect will alternate on (LED unlit) and off (LED
lit) each time you press SW1 (or SW2).
This is available only for the bank M programs.
CC#65 will be transmitted each time this is turned on/off (OFF value is 0, ON value is 127).
If
Modulation
is selected, the switch can be the source for Alternate Modulation or Effect
Dynamic Modulation. This is the only function which differs between SW1 and SW2; SW1 is
CC#80, and SW2 is CC#81.
CC#80 (or CC#81) will be transmitted each time the switch is turned on/off (OFF value is 0, ON
value is 127).
Portamento Off
will have no effect unless you are using a program from bank M (selected in
Program Play mode). On a
TRINITY
in which the MOSS-TRI option is not installed, the Porta-
mento OFF is just to turn portamento on/off on an external device.
To Next Page
Loading...
Need help?
General
