5–1: Amp 1 Mod (Amplifier 1 Modulation)
41
• High (Higher Ramp) [–99…+99]
With positive (+) settings, playing above the specified High note number (Keyboard Track Key)
will produce progressively louder levels, and with negative (–) settings will produce progressively
quieter levels.
Velocity [–99…+99]
With positive (+) settings, the volume will become louder as you play more strongly.
With negative (–) settings, the volume will become quieter as you play more strongly.
Aftertouch [–99…+99]
With positive (+) settings, the volume will become louder as you press on the keyboard. With a
setting of +99, you can produce a change of up to 8 times the volume. However if the EG settings
etc. have already set the volume at maximum, it will not be possible to increase the volume fur-
ther.
With negative (–) settings, the volume will decrease as you press on the keyboard.
Alternate Modulation
AMS (Alternate Modulation Source) [OFF…Tempo]
Selects the modulation source.
With a setting of OFF, modulation will not be applied.
Intensity [–99…+99]
Since the volume is determined by multiplying the volume change produced by the Amp EG with
the values of Alternate Modulation, etc., low levels of the Amp EG will mean that the modulation
applied by Alternate Modulation will also be low.
If AMS is EG or LFO, a maximum of 8 times the amount of change can be applied from a volume
of 0. (The LFO allows an additional offset.) If you wish to use another EG (pitch EG or filter EG) to
control the volume, set each of the Amp EG levels to the maximum value (99).
If AMS is set to a controller, positive (+) settings of this parameter will raise the volume, and neg-
ative (–) settings will lower the volume. The range is a maximum of 8x.
If AMS is set to SW1 or SW2, the volume can be adjusted by a maximum of 8x.
If AMS is Tempo and the Intensity is +33, doubling the tempo will raise the volume 2x (double).
However if the EG settings etc. have already set the volume at maximum, it will not be possible to
increase the volume further.
For details on how Alternate Modulation and the other AMS functions operate, refer to page 157
“8. Appendix” in this manual and to page 33 “About alternate modulation” in the Basic Guide.
Amplitude
Key
Low Ramp=–99
Low Ramp=0
Low Ramp=+99
High Ramp=+99
High Ramp=0
High Ramp=–99
Low Key
High Key
The effect of keyboard position and Ramp settings
Changes in volume (with positive (+) settings)
Softly played notes
Strongly played notes
Note-on
Note-off
Note-on
Note-off
To Next Page
Loading...
Need help?
General
