1–1: Timb Param1 (Timbre Parameter 1)
58
If “1–1d: Timbre Mode” is INT, programs can be selected via MIDI. When a combination is
selected on the TRINITY, timbres whose Timbre Mode is set to EXT will transmit the bank and
program number selected here via MIDI.
Bank [A…M]
Selects the bank for each timbre 1–8.
Bank M can be selected if the optional MOSS-TRI board is installed.
Program (Program Select) [0…127]
Selects the program for each timbre 1–8.
If the optional MOSS-TRI board is installed, programs 0–63 can be selected for bank M. In addi-
tion, if the Playback Sampler/Flash ROM option is installed, programs 64–127 can be selected for
bank M.
1–1d: Timbre Mode [OFF/INT/EXT]
This sets the Timbre Mode for timbres 1–8.
OFF:
The program will not sound. (Nor will MIDI data be transmitted.)
INT:
Playing the TRINITY’s keyboard will sound the internal tone generator, and the internal tone
generator will also sound in response to MIDI messages from external MIDI devices.
EXT:
Playing the TRINITY’s keyboard will not sound the internal tone generator, but will transmit
MIDI messages to control an external MIDI device.
1–1e: MIDI Channel [01…16, Gch]
This sets the MIDI transmit and receive channel for each timbre 1–8.
If
Gch
is selected, the MIDI channel of the timbre will always match the MIDI channel setting
specified in Global mode “1–1: Global Setup” (
☞
page 129 in this manual).
If “1–1d: Timbre Mode” is INT, the timbre will transmit MIDI messages on the channel specified
by this setting. If the setting is the same as the Global MIDI channel, the TRINITY’s keyboard will
play the internal tone generator.
If “1–1d: Timbre Mode” is EXT, playing the TRINITY’s keyboard will transmit MIDI messages on
the MIDI channel specified here. (The same messages will simultaneously be transmitted on the
Global MIDI channel as well.)
▼
Page Menu Command
1–1A: Write Combination
This command writes an edited combination into the specified combination number. Be sure to
write important combinations. If you turn the power off or select another combination before writ-
ing, it will not be possible to recover the edited data.
For details refer to Basic Guide page 23, “9. Writing programs and combinations”.
MIDI OUT
EXT
MIDI IN
INT
Tone
generator
To Next Page
Loading...
Need help?
General
