2–1: Pitch
62
2–1e: Bend Range [PRG, –24…+24]
Specifies the range (in chromatic steps) of the pitch change that will occur when the pitch bender
is operated.
With a setting of
PRG
, the pitch bend range specified by the program will be used.
With a setting of
–24
to
+24
, the pitch bend range will be as specified here, regardless of the setting
of the program.
▼
Page Menu Command
2–1A: Write Combination
This command writes an edited combination into the specified combination number. Be sure to
write important combinations. If you turn the power off or select another combination before writ-
ing, it will not be possible to recover the edited data.
For details refer to Basic Guide page 23, “9. Writing a program or combination”.
To Next Page
Loading...
