Standalone Wi-Fi
Select the Standalone Wi-Fi checkbox to create an autonomous network (without
Internet access).
Once defined as required, click Apply before rebooting your device.
Notes:
Install VIA GO in a way that all client devices are no farther than 5 meters
from it, with no obstructions and minimum interferences.
Prior to selecting a broadcast channel for your network, we recommend you
use a Wi-Fi analyzer, to identify the cleanest channel available in your
environment (to avoid congested channels). Different programs and
applications are available (free or at reasonable cost) and your Sales
Representative can recommend you some of these tools.
When using the Wi-Fi as a secondary Access Point to the LAN one, make
sure to deactivate the “standalone” check box and to connect your LAN
cable to the RJ-45 connector of VIA GO. Your LAN network can be set to
Static IP or DHCP, as per your preference.
For your VIA GO to offer Internet access to your guests connected to the
built-in AP, don’t forget to check the “Enable Internet” box in the menu. The
traffic over the TCP/IP Port 80 must be allowed on the main network. Refer
to our “IT Deployment Guide” for more details about all port requirements.
When VIA GO is configured in AP mode, the “USB Creator” feature creates a
profile that can be used by either PC or MAC laptops’ users. This USB dongle can
be connected to the user’s laptop to automatically launch the Kramer VIA app,
connecting it to VIA GO. The only thing to do is now to click Present from the VIA
menu to start sharing a content on the main display.
To create this profile dongle, make sure that your unit is ALREADY configured to
AP mode and is rebooted after applying the settings:
1. Plug in a USB drive
WARNING: The plugged USB drive is formatted to the FAT32 format.
2. Check the required box - Windows Client or Mac Client as per user’s need.
To Next Page
Loading...
