Kramer VIA GO

58
VIA GO - Configuring VIA GO
To configure a gateway to be managed from VSM:
1. Click VIA Management > VIA Site Management on the left tabs of the VIA
web pages.
The VIA Site Management tab appears.
Figure 35: VIA Web pages – VIA Site Management Tab
2. Type the VSM Server IP.
3. Type the Gateway ID that was defined in VSM for this gateway.
4. Click Validate and Save.
Changes take effect immediately.
The VIA device (Collage, Connect Pro, Campus, or Go) must be able to
connect to VSM while validating is in progress.
-OR-
Click Save for changes to be saved with no validation from VSM.
Since validation is not made immediately, any error entered at this stage –
like duplication of ID must be corrected manually at a later stage.