7.1.3.2 Client Wi-Fi Mode
In Client mode, the VIA GO built-in Wi-Fi module is configured to provide 2.4GHz
and 5GHz bands support, IEEE 802.11abgn, 802.11ac, 802.11i, 802.11h, 802.11w
with WEP 64bit-128bit, AES-CCMP, TKIP, WPA, WPA2, WPA2 Enterprise 802.1X
(EAP-TLS, PEAP, EAP-FAST), PAP, CHAP, TLS, MS-CHAP, MS-CHAPv2 security
level.
To connect your VIA GO as a client device to your main network:
1. Browse for and select an available network.
2. Enter the required password.
3. Click Apply.
4. Disconnect the LAN cable (if connected).
5. Reboot your device.
To connect your VIA GO as a client device to your main network while
simultaneously using the LAN primary network:
1. Browse for and select an available network.
2. Enter the required password.
3. Select the Enable Dual Network checkbox
To Next Page
Loading...
