VII - 14
Working with the Big Pack Baler
7.10 Multi-Bale Device(optional)
In the Multi-Bale design, the entire big bale can be
divided up into as may as 6 small bales.
The complete bale are held together by 4 twines, while
small bales are held together by 2 twines each. If the
Multi-Bale function is turned off, the conventional big
bale is still bound up by 6 twines.
The number of small bales selected can be 2-6
(depending on the length of the total bale).
This results in a variable length of the small bale of from
0.45 m to 1.35 m.
The parameters can be set from the control panel on the
tractor (refer to Chapter “Setting the number of Multi-
Bales” on page IV-11)
If the Multi-Bale function has been previously selected,
the small bales are tied with the front needle yoke (1).
The entire bale is tied with the needle yoke (2) that is
connected in the rear.
A pneumatic cylinder (3) is used to couple the individual
needle yokes. The cylinder activates the interlock
ratchet mechanism (5). The control block of the
pneumatic cylinder (3) is controlled directly by the
Comfort electronics.
• If the Multi-Bale function is not
needed for an extended period of
time, the two needle yokes can be
locked in place with the perforated
bar (4). This reduces wear in the
individual components.
• If the Multi-Bale function is selected
with the control unit when the needle
yoke is locked, this function will not
be executed. An error message
appears in the control unit display.
• If you are using the machine with
Multi-Bale, make certain to use a
high-quality twine (110-130m/kg) at
higher bale densities for the 4 twines.
The entire bale is supported by just 4
twines.
• To break up the entire bale into small
bales, untie the twines (1, 3, 4, 6).
1
2
3
4
BPXC0241
5
1
2
3
4
5
6
BPXC0250
To Next Page
Loading...
