IX - 10
Care and Maintenance
There is danger of injury!
Before disassembling the membrane
brake cylinder, bleed the excess pressure
out of the compressed air system.
No special maintenance is required for the brake cylinder
(1). At least once every two years the membrane brake
cylinders should be removed, disassembled, cleaned,
fitted with new wear parts and reassembled.
9.5.4 Brake Cylinders
BP380-7-085
1
9.5.3 Adjusting the Transfer Mechanism
Brake setting
Depending on how the machine is used, the wear on and
proper functionality of the brakes must be checked
regularly and reset if necessary.
After the first few kilometres of driving, the transfer
mechanisms and the brake linings of the brake drum will
have adjusted. The play resulting from this must be
compensated for.
Adjusting the linkage setter
- Every 200 hours of operation -
Activate the linkage setter manually in the pressure
direction. The setting of the linkage setter must be
changed if there is a clear path (a) of max. 35 mm.
The setting is made with the adjustment screw (b) on the
linkage setter.
Set the clear path “a” to 10 - 12 % of the connected
brake lever length "B”,
For example, lever length 125 mm = clear path 12 -
15 mm.
BPXC0178
a
3
2
1
b
To Next Page
Loading...
