IV - 49
ISO Control
4.12 ISO Control
4.12.2 Mounting
When mounting the control unit, make
certain the connection cables are not
stretched and cannot come in contact
with the tractor wheels.
LBS_0002
1
4.12.1 Working Principle
ISO control is used exclusively for machines and systems that are compliant with Application Level 1 of International
Standards Organisation (ISO) 11783. The purpose of ISO 11783 is to provide a complete uniform system for
electronic systems in the vehicle. The uniform, easy to understand system required by ISO 11783 is intended to
facilitate communication between the different electronic control units. The purpose of simple adjustable control
elements that are separate from the actual display is to make it possible to use the display as a performance monitor
for the tractor and as a monitor for an ISO-11783 attached device.
Install the cable harness included with delivery.
To do this:
• Connect the power supply cable (12 V) on the
tractor side to the 3-prong power outlet (DIN 9680)
and on the machine side with the Delphi plug (5).
• The Delphi plug (5) is located on the left-hand side
of the machine (in the direction of travel) on the
metal cover close to the flywheel.
• Connect the cable included with delivery to the
socket (4) on the metal cover on the left-hand side
(in the direction of travel) close to the flywheel. Also
connect with the socket of the control unit.
• Attach the 9-pin ISO plug to the ISO bus socket (1)
on the tractor.
BPK40659
5
4
To Next Page
Loading...
