Krone Big Pack 890 XC - Holding Brake for Flywheel; Adjusting the Drawbar Height

III - 3
Start-up and Transport
• Secure the Big Pack Baler against rolling away with wheel chocks and by applying the
parking brake.
• Use suitable supporting blocks for supporting the Big Pack Baler.
• There is a risk of crushing one’s feet when cranking down the parking support.
Before starting the adjustment set the Big Pack Baler on the parking support and uncouple the tractor.
The drawbar can be adjusted optionally for top or bottom
attachment.
Both in the “top attachment” position and in the “bottom
attachment” position the Big Pack Baler can still be
adapted in height to the hitching height of the tractor
(hitch or swinging drawbar).
To guarantee optimum working, the Big Pack Baler must
be hitched horizontally. The top edge of the twine box
serves as reference edge in this case.
Setting the hitching height:
• For the adjustment of the drawbar height the hitch (2)
can be adjusted in height by loosening the screws
(1).
• If this is not sufficient the side parts (4) can be
adjusted in height by additionally loosening the
screws (3).
• For adjusting to bottom attachment the two side
parts (4) are turned round.
For the tightening torques, see Chapter 9.2.1.
3.2.5Adjusting the Drawbar Height
The flywheel holding brake (belt brake) is located on the
left side on the machine on the drawbar.
• To brake the flywheel move the brake lever (1) on the
flywheel from position (a) into position (b). The
flywheel is now braked.
When the electronics are turned on, the Big Pack Baler
emits a horn signal.
Caution! Before engaging the PTO always
release the holding brake first.
3.2.4Holding Brake for Flywheel
1
4
BPXC0111
2
3
BPXC0110
1
4
2
3
BPXC0201
a
b
1