Krone Big Pack 890 XC - Electrical Connection Cables

III - 9
Start-up and Transport
As soon as the plug of the continuous
current supply is plugged in and the
control and display unit is switched on
and there is no twine in the needles, the
acoustic signal of the twine control
sounds.
3.5.6 Electrical Connection Cables
The Big Pack Baler requires a voltage source for the
power supply of the on-board computer and lighting. A
socket for installation on the tractor is part of the scope
of supply.
• The socket included with delivery can be connected
directly to the 12-V battery of the tractor
• Plug in and secure the connection cables in the
corresponding sockets on the baler.
• Remove the protective cap before plugging in if
necessary.
Socket 1: Connection cable between on-board
computer and control panel on the
tractor.
Socket 2: Power supply of the on-board computer.
Connect the connection on the plug side
with the mounted socket.
Socket 3: 7-pin standard socket for lighting (working
floodlights (4))
BPXC0118
2
1
3
BP1213024
4
5
The working floodlights (4) are supplied with power
through the parking light of the tractor.
• They are switched on or off by actuating the rotary
switch (5) of the working floodlights.
The working floodlights (4) only work
when the parking light is turned on