Krone Big Pack 890 XC - Checking and Changing the Oil on the Gearboxes; General Information; Main Gearbox; Packer Gearbox

IX - 6
Care and Maintenance
Checking the oil level
9.4.2 Main Gearbox
The oil viewing glass (3) and drain screws (2) are
located on the left side of the main gearbox (1).
Changing the oil
Check the oil level in the main gearbox each time before
using the machine. The oil level must be visible in the
oil viewing glass (3).
Replace the oil after every season. To do this, remove
the control screw (3) and the oil drain screw (2). Capture
the oil in a suitable container as it drains out. Screw in
the oil drain screw again and refill with fresh oil up to the
control drill hole. Screw in the control screw again.
9.4 Checking and Changing the Oil on the Gearboxes
9.4.1 General Information
• When checking the oil level on the gearboxes, care must be taken that the Big Pack Baler is in
a horizontal position. Use the lower edges of the twine boxes as a reference surface.
• The oils and filling quantities to be used for the respective gear boxes are listed in the
“Technical data”.
• During the season, check all gearbox oil levels daily before using the machine and top off if
necessary.
9.4.3 Packer Gearbox
The packer gearbox (3) is located on the left side of the
machine.
Checking the oil level
Changing the oil
Check the oil level in the packer gearbox (3) each time
before using the machine. To do this, screw out the
control screw (1). The oil level must reach up to the
control drill hole. If necessary, top off the oil. After you
have checked, screw in the control screw again.
Replace the oil after every season. To do this, remove
the control screw (1) and the oil drain screw (2). Capture
the oil in a suitable container as it drains out. Screw in
the oil drain screw again and refill with fresh oil up to the
control drill hole. Screw in the control screw again.
BPXC0176
1
2
3
BPXC0248
3
2
1