Krone EasyCut B 970 - Oils; Lubricating Greases

4 Technical data
4.1 Consumables
36
EasyCut B 970
Original Operating Instructions 150000711_01_en
NOTICE
Mixing types of oil
If types of oil are mixed, the machine could be damaged.
 Never mix different types of oil.
 Before changing the type of oil, consult customer service. Never use engine oil.
Bio-degradable lubricants on request
4.1.1 Oils
Designation Filling quantity Specification Initial filling ex works
Input gearbox 1.7 l SAE 90 Wiolin ML 4 SAE 90
Main gearbox 0.4 l each SAE 90 Wiolin ML 4 SAE 90
Cutterbar x 8.0 l each SAE 90 Wiolin ML 4 SAE 90
The filling quantities of the gearboxes are guide values. The correct values result from oil
change/oil level check, refer to page74.
4.1.2 Lubricating greases
Designation Filling quantity Specification
Manual lubrication points As required
1
Lubricating grease to DIN
51818 of NLGI class 2, Li
soap with EP additives
1
Lubricate the manual lubrication point until grease escapes at the bearing position. After
lubricating, remove the grease escaping from the bearing position.