Krone EasyCut B 970 - Checking Guard Cloths; Cleaning the Machine

11 Maintenance - General Information
11.5 Checking guard cloths
72
EasyCut B 970
Original Operating Instructions 150000711_01_en
11.5 Checking guard cloths
KMG000-010
ü The machine is in the working position, refer to page52.
ü The machine is shut down and safeguarded, refer to page24.
 Carry out a visual inspection of the guard cloth (1) to ensure that there are no cracks and
damage.
Æ The machine can be used when there are no cracks or damages.
Æ Replace guard cloths in case of cracks or damage.
11.6 Cleaning the machine
WARNING
Eye damage caused by flying dirt particles!
When cleaning the machine with compressed air or with high-pressure cleaner, the dirt
particles are slung away at high speed. The dirt particles may hit the eyes and hurt them.
 Keep persons away from working range.
 When performing cleaning work with compressed air or with high-pressure cleaner, wear
suitable working clothes (for example eye protection).
NOTICE
Damage to the machine due to water damages with high-pressure cleaner
If the water jet from a high-pressure cleaner is aimed directly at bearings and electrical/
electronic components, these parts can be damaged.
 Do not aim the water jet from high-pressure cleaner at bearings and electrics/electronic
components.
ü The machine is shut down and safeguarded, refer to page24.
 After each use, remove husk and dust from the machine.