Krone EasyCut B 970 - Changing Blades for the Blade Screw Connection Version

14 Maintenance - Cutterbar
14.3 Check/change blades
80
EasyCut B 970
Original Operating Instructions 150000711_01_en
KM000-038
ü The machine is in the working position, refer to page52.
ü The machine is shut down and safeguarded, refer to page24.
 Fold up the front guard, refer to page49.
WARNING!Risk of injury due to sharp blades! Wear suitable protective gloves.
 Clean the area around the blades, cutting discs and mower drums.
 Check wear limit.
ð If the dimension is X>13mm, the wear limit is not reached.
ð If the dimension X is ≤13mm or the borehole touches the marking (1), the blade must
be replaced.
 Fold down the front guard, refer to page49.
14.3.2 Changing blades for the “blade screw connection” version
KM000-044
ü The machine is in the working position, refer to page52.
ü The machine is shut down and safeguarded, refer to page24.
 Fold up the front guard, refer to page49.
WARNING!Risk of injury due to sharp blades! Wear suitable protective gloves.
 Clean the area around the blades, cutting discs and mower drums.
 Remove the damaged or worn blade.
 Check the fastening elements of the blade, refer to page82. Also replace worn or
damaged fastening parts.