Krone EasyCut B 970 - 11 Maintenance - General Information; Maintenance Table; Maintenance - before the Season

Maintenance - General Information 11
Maintenance table 11.1
EasyCut B 970
Original Operating Instructions 150000711_01_en 65
11 Maintenance - General Information
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
 To avoid accidents, the relevant safety instructions must be read and observed, refer to
page13.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
 The safety routines must be read and observed to avoid accidents, refer to page24.
WARNING
Risk of injury caused by test run of the machine
If a test run is performed after repair, maintenance or cleaning work or after technical
intervention, the machine may behave unpredictably. Thus there is a risk of serious injuries or
death.
ü The machine is in working position.
 Do not switch on the drives until the mower is resting on the ground and you are
absolutely sure that there is no one in the danger zone.
 The test run of the machine must only be started from the driver's seat.
11.1 Maintenance table
11.1.1 Maintenance – Before the season
Checking oil level
Input gearbox refer to page74
Main gearbox refer to page75
Cutterbar refer to page87
Components
Change/replace blades refer to page79
Check/replace cutting discs/mower drums refer to page85
Check/change retaining bolts (blade screw
connection)
refer to page82
Check/replace retaining bolts (blade quick
fastener)
refer to page82
Check/change blade carrier (blade quick
fastener)
refer to page83
Check/replace abutting edge on the cutterbar refer to page86
Vent friction clutch refer to page70
Check/replace locking of the side guards refer to page63